|
L. Kang et al., “Introduction About Key Techniques of Critical Equipment in CSNS”, in Proc. 8th Int. Particle Accelerator Conf. (IPAC'17), Copenhagen, Denmark, May 2017, pp. 4548-4550. |
|
J. B. Yu et al., “Alignment and Calibration for Collimation System in CSNS/RCS”, in Proc. 8th Int. Particle Accelerator Conf. (IPAC'17), Copenhagen, Denmark, May 2017, pp. 3432-3435. |
|
X. J. Nie et al., “Structure Design of a Multi-Wire Target”, in Proc. 10th Mechanical Engineering Design of Synchrotron Radiation Equipment and Instrumentation Conf. (MEDSI'18), Paris, France, Jun. 2018, pp. 92-94. |
|
J. X. Chen et al., “Application of Remote Installation and Measurement Smart Vehicle in Accelerator”, in Proc. 10th Mechanical Engineering Design of Synchrotron Radiation Equipment and Instrumentation Conf. (MEDSI'18), Paris, France, Jun. 2018, pp. 217-219. |
|
J. B. Yu et al., “Research on Active Vibration Isolation System”, in Proc. 10th Mechanical Engineering Design of Synchrotron Radiation Equipment and Instrumentation Conf. (MEDSI'18), Paris, France, Jun. 2018, pp. 280-282. |
|
L. Kang et al., “Key Technologies for Remote Detection of CSNS Radiation Environment”, in Proc. 10th Int. Particle Accelerator Conf. (IPAC'19), Melbourne, Australia, May 2019, pp. 2584-2586. |
|
Y. Li et al., “Moderation of Positive Muons by Helium Gas”, in Proc. 10th Int. Particle Accelerator Conf. (IPAC'19), Melbourne, Australia, May 2019, pp. 3667-3669. |
|
A. X. Wang et al., “The Deformation-Stress Simulation and Measurement of Titanium Foil Strip for Hadron Monitor”, in Proc. 10th Int. Particle Accelerator Conf. (IPAC'19), Melbourne, Australia, May 2019, pp. 4187-4189. |
|
A. X. Wang et al., “STRUCTURAL OPTIMIZATION DESIGN OF FARADAY CUP FOR BEAM COMMISSIONING OF CSNS”, in Proc. 12th Int. Particle Accelerator Conf. (IPAC'21), Campinas, Brazil, May 2021, pp. 943-945. |
|
J. S. Zhang et al., “Optimization Design of Four-Point Vibration Isolation Support for Spallation Neutron Source Vibration Magnet”, in Proc. 12th Int. Particle Accelerator Conf. (IPAC'21), Campinas, Brazil, May 2021, pp. 4352-4354. |
