|
R. Valdiviez et al., “The Mechanical Design and Fabrication of a Ridge-Loaded Waveguide for an RFQ”, in Proc. 19th Int. LINAC Conf. (LINAC'98), Chicago, IL, USA, Aug. 1998, paper TU4083, pp. 597-599. |
|
K. Kishiyama, S. Shen, D. Behne, N. G. Wilson, D. Schrage, and R. Valdiviez, “Testing of Vacuum Pumps for the APT/LEDA RFQ”, in Proc. 19th Int. LINAC Conf. (LINAC'98), Chicago, IL, USA, Aug. 1998, paper TU4095, pp. 624-626. |
|
L. J. Rybarcyk, P. O. Leslie, R. Valdiviez, R. L. Wood, M. D. Cole, and J. M. Potter, “Tuning Section 2 of the LEDA CCDTL”, in Proc. 19th Particle Accelerator Conf. (PAC'01), Chicago, IL, USA, Jun. 2001, paper FPAH107, pp. 3927-3929. |
|
D. Barr et al., “Design and Experience with the WS/HS Assembly Movement Using LabVIEW VIs, National Instrument Motion Controllers, and Compumotor Electronic Drive Units and Motors”, in Proc. 19th Particle Accelerator Conf. (PAC'01), Chicago, IL, USA, Jun. 2001, paper MPPH012, pp. 794-796. |
|
J. D. Gilpatrick et al., “Beam-Profile Instrumentation for Beam-Halo Measurement: Overall Description and Operation”, in Proc. 19th Particle Accelerator Conf. (PAC'01), Chicago, IL, USA, Jun. 2001, paper ROAB004, pp. 525-527. |
|
R. Valdiviez, L. Earley, R. P. LaFave, F. Martinez, D. Nguyen, and A. Rendon, “The High-Heat Flux Testing of an Interceptive Device for an Intense Proton Beam”, in Proc. 19th Particle Accelerator Conf. (PAC'01), Chicago, IL, USA, Jun. 2001, paper TPAH044, pp. 1321-1323. |
|
R. Valdiviez et al., “The Final Mechanical Design, Fabrication, and Commissioning of a Wire Scanner and Scraper Assembly for Halo-Formation Measurements in a Proton Beam”, in Proc. 19th Particle Accelerator Conf. (PAC'01), Chicago, IL, USA, Jun. 2001, paper TPAH045, pp. 1324-1326. |
|
J. D. Gilpatrick et al., “Experience with the Low Energy Demonstration Accelerator (LEDA) Halo Experiment Beam Instrumentation”, in Proc. 19th Particle Accelerator Conf. (PAC'01), Chicago, IL, USA, Jun. 2001, paper WPAH097, pp. 2311-2313. |
|
T. Mottershead et al., “Design and Operation of a Proton Microscope for Radiography at 800 MeV”, in Proc. 20th Particle Accelerator Conf. (PAC'03), Portland, OR, USA, May 2003, paper FOAA004, pp. 702-704. |
|
R. Valdiviez et al., “The Mechanical Design of a Proton Microscope for Radiography at 800 MeV”, in Proc. 20th Particle Accelerator Conf. (PAC'03), Portland, OR, USA, May 2003, paper TPPB020, pp. 1664-1666. |
