Warning
Some papers titles are all uppercase, you must correct this before using this reference.
The page numbers for some of these references could not be added automatically. You must provide the page numbers from the original proceedings which is located at JACoW.org, and substitute ‘pp. XX-XX’ with the correct page numbers.
Favourites
For Word
[n] A. Tropp, P. Gu, and C. Christou, “Single bunch and multi bunch operation with single klystron using a programmable SLED system”, in Proc. LINAC'24, Chicago, IL, USA, Aug. 2024, pp. 95-97. doi:10.18429/JACoW-LINAC2024-MOPB027
[n] G. Wang et al., “On-resonance round beam experiment in the HLS-II storage ring”, in Proc. IPAC'23, Venice, Italy, May 2023, pp. 1079-1081. doi:10.18429/JACoW-IPAC2023-MOPM039
[n] Z. Greenwald, S. Greenwald, and D. Rice, “Simulation and Stability of a Crab Cavity”, in Proc. PAC'91, San Francisco, CA, USA, May 1991, pp. 1857-1860.
[n] H. A. Willax, “Present Status of the 590 MeV Ring Cyclotron of SIN”, in Proc. PAC'73, San Francisco, CA, USA, Mar. 1973, pp. 202-207.
[n] C. Belver-Aguilar et al., “Technology Selection for the Beam Position Tuning System in Hadrontherapy Facilities”, in Proc. DIPAC'11, Hamburg, Germany, May 2011, paper TUPD15, pp. 332-334.
[n] E.-C. Huang, P. Anisimov, and L. Rybarcyk, “Benchmarking HPSim with the LANSCE Linac”, in Proc. IPAC'23, Venice, Italy, May 2023, pp. 2480-2482. doi:10.18429/JACoW-IPAC2023-TUPM112
[n] S. Emhofer et al., “Commissioning-Results of the REX-ISOLDE Linac”, in Proc. PAC'03, Portland, OR, USA, May 2003, paper RPAB066, pp. 2869-2871.
[n] R. Veness et al., “Installation and Test of Pre-series Wire Scanners for the LHC Injector Upgrade Project at CERN”, in Proc. IPAC'17, Copenhagen, Denmark, May 2017, pp. 412-414. doi:10.18429/JACoW-IPAC2017-MOPAB121
[n] G. Reinhold and R. Gleyvod, “Megawatt HV DC Power Supplies”, in Proc. PAC'75, Washington D.C., USA, Mar. 1975, pp. 1289-1293.
[n] M. Bieler, I. V. Agapov, H. Ehrlichmann, J. Keil, G. K. Sahoo, and R. Wanzenberg, “PETRA III Operation”, in Proc. IPAC'17, Copenhagen, Denmark, May 2017, pp. 2589-2591. doi:10.18429/JACoW-IPAC2017-WEPAB014
[n] P. Y. Beauvais, R. Ferdinand, G. Haouat, and N. Pichoff, “Measurements of Initial Beam Conditions for Halo Formation Studies”, in Proc. EPAC'96, Sitges, Spain, Jun. 1996, paper MOP016L, pp. 1206-1208.
[n] T. Miyao, Z. Igarashi, T. Toyama, and A. Miura, “Beam Position Monitors for the ACS Section of the J-PARC Linac”, in Proc. DIPAC'11, Hamburg, Germany, May 2011, paper TUPD18, pp. 341-343.
[n] P. Shcherbakov et al., “COMPARATIVE ANALYSIS OF WIDE APERTURE DIPOLE DESIGNS FOR THE SIS300 RING”, in Proc. RuPAC'04, Dubna, Russia, Oct. 2004, paper THFP04, pp. XX-XX.
[n] W. Busse, “Control Systems Underway to be Implemented as Expert Systems”, in Proc. Cyclotrons'89, Berlin, Germany, May 1989, paper F4-01, pp. 236-239.
For LaTeX
Use Complete Form
For BibTeX
References
- A. Tropp, P. Gu, and C. Christou, “Single bunch and multi bunch operation with single klystron using a programmable SLED system”, in Proc. 32nd Linear Accelerator Conf. (LINAC'24), Chicago, IL, USA, Aug. 2024, pp. 95-97.
- G. Wang et al., “On-resonance round beam experiment in the HLS-II storage ring”, in Proc. 14th Int. Particle Accelerator Conf. (IPAC'23), Venice, Italy, May 2023, paper MOPM039, pp. 1079-1081.
- Z. Greenwald, S. Greenwald, and D. Rice, “Simulation and Stability of a Crab Cavity”, in Proc. 14th Particle Accelerator Conf. (PAC'91), San Francisco, CA, USA, May 1991, pp. 1857-1860.
- H. A. Willax, “Present Status of the 590 MeV Ring Cyclotron of SIN”, in Proc. 5th Particle Accelerator Conf. (PAC'73), San Francisco, CA, USA, Mar. 1973, pp. 202-207.
- C. Belver-Aguilar et al., “Technology Selection for the Beam Position Tuning System in Hadrontherapy Facilities”, in Proc. 10th European Workshop on Beam Diagnostics and Instrumentation for Particle Accelerators (DIPAC'11), Hamburg, Germany, May 2011, paper TUPD15, pp. 332-334.
- E.-C. Huang, P. Anisimov, and L. Rybarcyk, “Benchmarking HPSim with the LANSCE Linac”, in Proc. 14th Int. Particle Accelerator Conf. (IPAC'23), Venice, Italy, May 2023, paper TUPM112, pp. 2480-2482.
- S. Emhofer et al., “Commissioning-Results of the REX-ISOLDE Linac”, in Proc. 20th Particle Accelerator Conf. (PAC'03), Portland, OR, USA, May 2003, paper RPAB066, pp. 2869-2871.
- R. Veness et al., “Installation and Test of Pre-series Wire Scanners for the LHC Injector Upgrade Project at CERN”, in Proc. 8th Int. Particle Accelerator Conf. (IPAC'17), Copenhagen, Denmark, May 2017, pp. 412-414.
- G. Reinhold and R. Gleyvod, “Megawatt HV DC Power Supplies”, in Proc. 6th Particle Accelerator Conf. (PAC'75), Washington D.C., USA, Mar. 1975, pp. 1289-1293.
- M. Bieler, I. V. Agapov, H. Ehrlichmann, J. Keil, G. K. Sahoo, and R. Wanzenberg, “PETRA III Operation”, in Proc. 8th Int. Particle Accelerator Conf. (IPAC'17), Copenhagen, Denmark, May 2017, pp. 2589-2591.
- P. Y. Beauvais, R. Ferdinand, G. Haouat, and N. Pichoff, “Measurements of Initial Beam Conditions for Halo Formation Studies”, in Proc. 5th European Particle Accelerator Conf. (EPAC'96), Sitges, Spain, Jun. 1996, paper MOP016L, pp. 1206-1208.
- T. Miyao, Z. Igarashi, T. Toyama, and A. Miura, “Beam Position Monitors for the ACS Section of the J-PARC Linac”, in Proc. 10th European Workshop on Beam Diagnostics and Instrumentation for Particle Accelerators (DIPAC'11), Hamburg, Germany, May 2011, paper TUPD18, pp. 341-343.
- P. Shcherbakov et al., “COMPARATIVE ANALYSIS OF WIDE APERTURE DIPOLE DESIGNS FOR THE SIS300 RING”, in Proc. 19th Russian Particle Accelerator Conf. (RuPAC'04), Dubna, Russia, Oct. 2004, paper THFP04, pp. XX-XX.
- W. Busse, “Control Systems Underway to be Implemented as Expert Systems”, in Proc. 12th Int. Cyclotron Conf. and Their Applications (Cyclotrons'89), Berlin, Germany, May 1989, paper F4-01, pp. 236-239.
Back to search
