Warning
The page numbers for some of these references could not be added automatically. You must provide the page numbers from the original proceedings which is located at JACoW.org, and substitute ‘pp. XX-XX’ with the correct page numbers.
Favourites
For Word
[n] O. Mete et al., “Modeling of an Electron Injector for the AWAKE Project”, in Proc. IPAC'15, Richmond, VA, USA, May 2015, pp. 1762-1764. doi:10.18429/JACoW-IPAC2015-TUPJE059
[n] T. T. Thakker and S. P. Jamison, “Effect of Active Fibre Stabilization on Group and Phase Delay”, in Proc. FEL'12, Nara, Japan, Aug. 2012, paper TUPD39, pp. 329-331.
[n] A. A. Gevorgyan, V. S. Avagyan, B. Grigoryan, T. H. Mkrtchyan, A. S. Simonyan, and V. V. Vardanyan, “Design and Performance of Ultimate Vacuum System for the AREAL Test Facility”, in Proc. IPAC'14, Dresden, Germany, Jun. 2014, pp. 2311-2313. doi:10.18429/JACoW-IPAC2014-WEPME025
[n] R. von Hahn et al., “The Cryogenic Storage Ring Project at Heidelberg”, in Proc. EPAC'08, Genoa, Italy, Jun. 2008, paper MOPC137, pp. 394-396.
[n] F. H. O, G. Andonian, and J. B. Rosenzweig, “Permanent Magnet Quadrupole Final Focus System for the Muon Collider”, in Proc. IPAC'10, Kyoto, Japan, May 2010, paper WEPE077, pp. 3524-3526.
[n] S. H. Lee, J. Mulvey, M. Ramanathan, and B. X. Yang, “Design of X-Ray Beam Position Monitor for High Heat Load Front Ends of the Advanced Photon Source Upgrade”, in Proc. MEDSI'16, Barcelona, Spain, Sep. 2016, pp. 318-320. doi:10.18429/JACoW-MEDSI2016-WEPE04
[n] B. Koubek, A. Schempp, J. S. Schmidt, and J. Haeuser, “RF Setup of the MedAustron RFQ”, in Proc. LINAC'12, Tel Aviv, Israel, Sep. 2012, paper SUPB014, pp. 35-37.
[n] R. Tikhoplav et al., “Progress Report on Development of a High Resolution Transverse Diagnostic based on Fiber Optics”, in Proc. IPAC'12, New Orleans, LA, USA, May 2012, paper MOPPR090, pp. 996-998.
[n] A. Schempp, “4 Rod RFQ Injector for GSI Linac”, in Proc. PAC'89, Chicago, IL, USA, Mar. 1989, pp. 1093-1098.
[n] U. Ratzinger, H. Höltermann, B. Koubek, H. Podlech, and M. Vretenar, “Linac Design within HITRIplus for Particle Therapy”, in Proc. LINAC'22, Liverpool, UK, Aug.-Sep. 2022, pp. 134-137. doi:10.18429/JACoW-LINAC2022-MOPOGE01
[n] C. M. Chu et al., “SNS Application Programming Infrastructure and Physics Applications”, in Proc. APAC'04, Gyeongju, Korea, Mar. 2004, paper MOM202, pp. XX-XX.
[n] Y. Ivanyushenkov, “A Concept of a Universal Superconducting Undulator”, in Proc. IPAC'14, Dresden, Germany, Jun. 2014, pp. 2050-2052. doi:10.18429/JACoW-IPAC2014-WEPRO048
[n] R. Apsimon, J. Esberg, A. Latina, D. Schulte, and J. A. Uythoven, “Design Considerations of the Final Turnaround Regions for the CLIC Drive Beam”, in Proc. IPAC'14, Dresden, Germany, Jun. 2014, pp. 485-488. doi:10.18429/JACoW-IPAC2014-MOPME049
[n] B. D. O et al., “Demonstration of Gigavolt-per-meter Accelerating Gradients using Cylindrical Dielectric-lined Waveguides”, in Proc. IPAC'14, Dresden, Germany, Jun. 2014, pp. 965-967. doi:10.18429/JACoW-IPAC2014-TUOBB02
[n] F. Jackson et al., “Electron Beam Dynamics in the ALICE IR-FEL Facility”, in Proc. FEL'12, Nara, Japan, Aug. 2012, paper WEPD42, pp. 464-467.
[n] A. Bertrand and R. Krempaska, “EPICS on the WEB”, in Proc. ICALEPCS'05, Geneva, Switzerland, Oct. 2005, paper P3_087.
[n] V. V. Paramonov, V. Danielyan, A. S. Simonyan, V. M. Tsakanov, and K. Floettmann, “Start of Operation of a Standing Wave Deflecting Cavity With the Minimized Level of Aberrations”, in Proc. RuPAC'18, Protvino, Russia, Oct. 2018, pp. 388-390. doi:10.18429/JACoW-RUPAC2018-WEPSB53
[n] W. F. Henning Gesellschaft f??r Schwerionenforschung, “The Future of Nuclear Physics in Europe and the Demands on Accelerators techniques”, in Proc. DIPAC'03, Mainz, Germany, May 2003, paper IT01, pp. XX-XX.
[n] A. Wolski, J. Nelson, M. C. Ross, and M. Woodley, “Initial Results from Model Independent Analysis of the KEK ATF”, in Proc. EPAC'02, Paris, France, Jun. 2002, paper WEPLE075, pp. 1205-1207.
For LaTeX
Use Complete Form
For BibTeX
References
- O. Mete et al., “Modeling of an Electron Injector for the AWAKE Project”, in Proc. 6th Int. Particle Accelerator Conf. (IPAC'15), Richmond, VA, USA, May 2015, pp. 1762-1764.
- T. T. Thakker and S. P. Jamison, “Effect of Active Fibre Stabilization on Group and Phase Delay”, in Proc. 34th Int. Free Electron Laser Conf. (FEL'12), Nara, Japan, Aug. 2012, paper TUPD39, pp. 329-331.
- A. A. Gevorgyan, V. S. Avagyan, B. Grigoryan, T. H. Mkrtchyan, A. S. Simonyan, and V. V. Vardanyan, “Design and Performance of Ultimate Vacuum System for the AREAL Test Facility”, in Proc. 5th Int. Particle Accelerator Conf. (IPAC'14), Dresden, Germany, Jun. 2014, pp. 2311-2313.
- R. von Hahn et al., “The Cryogenic Storage Ring Project at Heidelberg”, in Proc. 11th European Particle Accelerator Conf. (EPAC'08), Genoa, Italy, Jun. 2008, paper MOPC137, pp. 394-396.
- F. H. O, G. Andonian, and J. B. Rosenzweig, “Permanent Magnet Quadrupole Final Focus System for the Muon Collider”, in Proc. 1st Int. Particle Accelerator Conf. (IPAC'10), Kyoto, Japan, May 2010, paper WEPE077, pp. 3524-3526.
- S. H. Lee, J. Mulvey, M. Ramanathan, and B. X. Yang, “Design of X-Ray Beam Position Monitor for High Heat Load Front Ends of the Advanced Photon Source Upgrade”, in Proc. 9th Mechanical Engineering Design of Synchrotron Radiation Equipment and Instrumentation Conf. (MEDSI'16), Barcelona, Spain, Sep. 2016, pp. 318-320.
- B. Koubek, A. Schempp, J. S. Schmidt, and J. Haeuser, “RF Setup of the MedAustron RFQ”, in Proc. 26th Linear Accelerator Conf. (LINAC'12), Tel Aviv, Israel, Sep. 2012, paper SUPB014, pp. 35-37.
- R. Tikhoplav et al., “Progress Report on Development of a High Resolution Transverse Diagnostic based on Fiber Optics”, in Proc. 3rd Int. Particle Accelerator Conf. (IPAC'12), New Orleans, LA, USA, May 2012, paper MOPPR090, pp. 996-998.
- A. Schempp, “4 Rod RFQ Injector for GSI Linac”, in Proc. 13th Particle Accelerator Conf. (PAC'89), Chicago, IL, USA, Mar. 1989, pp. 1093-1098.
- U. Ratzinger, H. Höltermann, B. Koubek, H. Podlech, and M. Vretenar, “Linac Design within HITRIplus for Particle Therapy”, in Proc. 31st Linear Accelerator Conf. (LINAC'22), Liverpool, UK, Aug.-Sep. 2022, pp. 134-137.
- C. M. Chu et al., “SNS Application Programming Infrastructure and Physics Applications”, in Proc. 3rd Asian Particle Accelerator Conf. (APAC'04), Gyeongju, Korea, Mar. 2004, paper MOM202, pp. XX-XX.
- Y. Ivanyushenkov, “A Concept of a Universal Superconducting Undulator”, in Proc. 5th Int. Particle Accelerator Conf. (IPAC'14), Dresden, Germany, Jun. 2014, pp. 2050-2052.
- R. Apsimon, J. Esberg, A. Latina, D. Schulte, and J. A. Uythoven, “Design Considerations of the Final Turnaround Regions for the CLIC Drive Beam”, in Proc. 5th Int. Particle Accelerator Conf. (IPAC'14), Dresden, Germany, Jun. 2014, pp. 485-488.
- B. D. O et al., “Demonstration of Gigavolt-per-meter Accelerating Gradients using Cylindrical Dielectric-lined Waveguides”, in Proc. 5th Int. Particle Accelerator Conf. (IPAC'14), Dresden, Germany, Jun. 2014, pp. 965-967.
- F. Jackson et al., “Electron Beam Dynamics in the ALICE IR-FEL Facility”, in Proc. 34th Int. Free Electron Laser Conf. (FEL'12), Nara, Japan, Aug. 2012, paper WEPD42, pp. 464-467.
- A. Bertrand and R. Krempaska, “EPICS on the WEB”, in Proc. 10th Int. Conf. on Accelerator and Large Experimental Physics Control Systems (ICALEPCS'05), Geneva, Switzerland, Oct. 2005, paper P3_087.
- V. V. Paramonov, V. Danielyan, A. S. Simonyan, V. M. Tsakanov, and K. Floettmann, “Start of Operation of a Standing Wave Deflecting Cavity With the Minimized Level of Aberrations”, in Proc. 26th Russian Particle Accelerator Conf. (RuPAC'18), Protvino, Russia, Oct. 2018, pp. 388-390.
- W. F. Henning Gesellschaft f??r Schwerionenforschung, “The Future of Nuclear Physics in Europe and the Demands on Accelerators techniques”, in Proc. 6th European Workshop on Beam Diagnostics and Instrumentation for Particle Accelerators (DIPAC'03), Mainz, Germany, May 2003, paper IT01, pp. XX-XX.
- A. Wolski, J. Nelson, M. C. Ross, and M. Woodley, “Initial Results from Model Independent Analysis of the KEK ATF”, in Proc. 8th European Particle Accelerator Conf. (EPAC'02), Paris, France, Jun. 2002, paper WEPLE075, pp. 1205-1207.
Back to search
