Warning
Some papers titles are all uppercase, you must correct this before using this reference.
The page numbers for some of these references could not be added automatically. You must provide the page numbers from the original proceedings which is located at JACoW.org, and substitute ‘pp. XX-XX’ with the correct page numbers.
Favourites
For Word
[n] L. Reginato, “The Advanced Test Accelerator (ATA), a 50-MeV, 10-kA Induction Linac”, in Proc. PAC'83, Santa Fe, NM, USA, Mar. 1983, pp. 2970-2975.
[n] H. Kabumoto, N. Ishizaki, M. Matsuda, Y. Otokawa, and S. Takeuchi, “Superconducting Twin Quarter Wave Resonator for Acceleration of Low Velocity Heavy Ions”, in Proc. SRF'09, Berlin, Germany, Sep. 2009, paper THPPO093, pp. 849-853.
[n] A. Faugier et al., “High Intensity Proton Beams in a Multi-cycled SPS”, in Proc. PAC'95, Dallas, TX, USA, May 1995, paper WAP12, pp. 464-466.
[n] J. Komatsu et al., “Dependence of the Wall-Current Monitor on the Beam Position”, in Proc. LINAC'94, Tsukuba, Japan, Aug. 1994, paper TH-62, pp. 848-850.
[n] E. Vogel et al., “Accelerator Module Repair for the European XFEL Installation”, in Proc. SRF'17, Lanzhou, China, Jul. 2017, pp. 82-86. doi:10.18429/JACoW-SRF2017-MOPB015
[n] J. Manczak et al., “Refined FLUKA simulation model of neutrino-induced effective dose from a multi-TeV muon collider”, presented at the IPAC'25, Taipei, Taiwan, Jun. 2025, paper TUPM076, unpublished.
[n] D. Kuchler et al., “Operational Experience with the GTS-LHC Ion Source and Future Developments of the CERN Ion Injector”, in Proc. ECRIS'12, Sydney, Australia, Sep. 2012, paper TUPP10, pp. 57-60.
[n] S. Myers, “LHC Commissioning and First Operation”, in Proc. IPAC'10, Kyoto, Japan, May 2010, paper MOXBMH01, pp. 6-10.
[n] B. Brajuskovic, P. Den Hartog, and E. Trakhtenberg, “Mechanical Analysis of the Prototype Undulator for the Linac Coherent Light Source”, in Proc. PAC'03, Portland, OR, USA, May 2003, paper MPPG001, pp. 1017-1019.
[n] D. Bolkhovityanov, P. B. Cheblakov, and F. A. Emanov, “CXv4, a Modular Control System”, in Proc. ICALEPCS'15, Melbourne, Australia, Oct. 2015, pp. 915-918. doi:10.18429/JACoW-ICALEPCS2015-WEPGF093
[n] S. H. Kim, T. G. Berenc, J. Carwardine, G. Decker, M. P. Kelly, and P. N. Ostroumov, “Design Study of the Higher Harmonic Cavity for Advanced Photon Source Upgrade”, in Proc. IPAC'15, Richmond, VA, USA, May 2015, pp. 1819-1821. doi:10.18429/JACoW-IPAC2015-TUPJE076
[n] J. Galambos, “High Power Proton Beam Targets: Technological Evolution, Current Challenges, and the Future”, in Proc. IPAC'16, Busan, Korea, May 2016, pp. 1075-1079. doi:10.18429/JACoW-IPAC2016-TUZB01
[n] K. R. Crandall, “Transverse Beam Matching Using Wire Scanners”, in Proc. LINAC'72, Los Alamos, NM, USA, Oct. 1972, paper C01, pp. 51-53.
[n] Y. Zhang, H. Jia, X. C. Kang, M. Li, J. X. Wu, and G. Zhu, “Design and Test Status of Beam Position Monitors for ADS Injector II Proton LINAC”, in Proc. IPAC'13, Shanghai, China, May 2013, paper MOPME045, pp. 574-576.
[n] D. B. Shwartz et al., “VEPP-2000 Collider Operation in Full Energy Range with New Injector”, in Proc. RuPAC'18, Protvino, Russia, Oct. 2018, pp. 7-11. doi:10.18429/JACoW-RUPAC2018-MOXMH02
[n] S. M. Gurov et al., “Large Aperture Quadrupole Magnets for ISIS TS-1 and TS-2”, in Proc. PAC'11, New York, NY, USA, Mar.-Apr. 2011, paper TUP146, pp. 1103-1105.
[n] J. V. Lebacqz, “Status Report on Klystron Improvements”, in Proc. PAC'75, Washington D.C., USA, Mar. 1975, pp. 1324-1328.
[n] N. Lipkowitz et al., “Longitudinal Beam Tuning at FACET”, in Proc. IPAC'12, New Orleans, LA, USA, May 2012, paper TUPPC052, pp. 1287-1289.
[n] S. V. Shiyankov et al., “PROJECT OF DEUTERON ACCELERATOR BASED CARBON TARGET FOR NEUTRON PRODUCTION”, in Proc. APAC'01, Beijing, China, Sep. 2001, paper THP037, pp. XX-XX.
[n] J. Peters, “A Phase Measurement System for RF Pulses”, in Proc. LINAC'88, Williamsburg, VA, USA, Oct. 1988, paper TH3-04, pp. 535-537.
[n] R. Demitra, A. Biagioni, L. Crincoli, M. Ferrario, and R. Pompili, “3D characterization of plasma density in capillary discharges for plasma-based accelerators”, presented at the IPAC'25, Taipei, Taiwan, Jun. 2025, paper TUPS113, unpublished.
For LaTeX
Use Complete Form
For BibTeX
References
- L. Reginato, “The Advanced Test Accelerator (ATA), a 50-MeV, 10-kA Induction Linac”, in Proc. 10th Particle Accelerator Conf. (PAC'83), Santa Fe, NM, USA, Mar. 1983, pp. 2970-2975.
- H. Kabumoto, N. Ishizaki, M. Matsuda, Y. Otokawa, and S. Takeuchi, “Superconducting Twin Quarter Wave Resonator for Acceleration of Low Velocity Heavy Ions”, in Proc. 14th Int. Conf. RF Superconductivity (SRF'09), Berlin, Germany, Sep. 2009, paper THPPO093, pp. 849-853.
- A. Faugier et al., “High Intensity Proton Beams in a Multi-cycled SPS”, in Proc. 16th Particle Accelerator Conf. (PAC'95), Dallas, TX, USA, May 1995, paper WAP12, pp. 464-466.
- J. Komatsu et al., “Dependence of the Wall-Current Monitor on the Beam Position”, in Proc. 1994 Linear Accelerator Conf. (LINAC'94), Tsukuba, Japan, Aug. 1994, paper TH-62, pp. 848-850.
- E. Vogel et al., “Accelerator Module Repair for the European XFEL Installation”, in Proc. 18th Int. Conf. RF Superconductivity (SRF'17), Lanzhou, China, Jul. 2017, pp. 82-86.
- J. Manczak et al., “Refined FLUKA simulation model of neutrino-induced effective dose from a multi-TeV muon collider”, presented at the 16th Int. Particle Accelerator Conf. (IPAC'25), Taipei, Taiwan, Jun. 2025, paper TUPM076, this conference.
- D. Kuchler et al., “Operational Experience with the GTS-LHC Ion Source and Future Developments of the CERN Ion Injector”, in Proc. 20th Int. Workshop on ECR Ion Sources (ECRIS'12), Sydney, Australia, Sep. 2012, paper TUPP10, pp. 57-60.
- S. Myers, “LHC Commissioning and First Operation”, in Proc. 1st Int. Particle Accelerator Conf. (IPAC'10), Kyoto, Japan, May 2010, paper MOXBMH01, pp. 6-10.
- B. Brajuskovic, P. Den Hartog, and E. Trakhtenberg, “Mechanical Analysis of the Prototype Undulator for the Linac Coherent Light Source”, in Proc. 20th Particle Accelerator Conf. (PAC'03), Portland, OR, USA, May 2003, paper MPPG001, pp. 1017-1019.
- D. Bolkhovityanov, P. B. Cheblakov, and F. A. Emanov, “CXv4, a Modular Control System”, in Proc. 15th Int. Conf. on Accelerator and Large Experimental Physics Control Systems (ICALEPCS'15), Melbourne, Australia, Oct. 2015, pp. 915-918.
- S. H. Kim, T. G. Berenc, J. Carwardine, G. Decker, M. P. Kelly, and P. N. Ostroumov, “Design Study of the Higher Harmonic Cavity for Advanced Photon Source Upgrade”, in Proc. 6th Int. Particle Accelerator Conf. (IPAC'15), Richmond, VA, USA, May 2015, pp. 1819-1821.
- J. Galambos, “High Power Proton Beam Targets: Technological Evolution, Current Challenges, and the Future”, in Proc. 7th Int. Particle Accelerator Conf. (IPAC'16), Busan, Korea, May 2016, pp. 1075-1079.
- K. R. Crandall, “Transverse Beam Matching Using Wire Scanners”, in Proc. 1972 Proton Linear Accelerator Conf. (LINAC'72), Los Alamos, NM, USA, Oct. 1972, paper C01, pp. 51-53.
- Y. Zhang, H. Jia, X. C. Kang, M. Li, J. X. Wu, and G. Zhu, “Design and Test Status of Beam Position Monitors for ADS Injector II Proton LINAC”, in Proc. 4th Int. Particle Accelerator Conf. (IPAC'13), Shanghai, China, May 2013, paper MOPME045, pp. 574-576.
- D. B. Shwartz et al., “VEPP-2000 Collider Operation in Full Energy Range with New Injector”, in Proc. 26th Russian Particle Accelerator Conf. (RuPAC'18), Protvino, Russia, Oct. 2018, pp. 7-11.
- S. M. Gurov et al., “Large Aperture Quadrupole Magnets for ISIS TS-1 and TS-2”, in Proc. 24th Particle Accelerator Conf. (PAC'11), New York, NY, USA, Mar.-Apr. 2011, paper TUP146, pp. 1103-1105.
- J. V. Lebacqz, “Status Report on Klystron Improvements”, in Proc. 6th Particle Accelerator Conf. (PAC'75), Washington D.C., USA, Mar. 1975, pp. 1324-1328.
- N. Lipkowitz et al., “Longitudinal Beam Tuning at FACET”, in Proc. 3rd Int. Particle Accelerator Conf. (IPAC'12), New Orleans, LA, USA, May 2012, paper TUPPC052, pp. 1287-1289.
- S. V. Shiyankov et al., “PROJECT OF DEUTERON ACCELERATOR BASED CARBON TARGET FOR NEUTRON PRODUCTION”, in Proc. 2nd Asian Particle Accelerator Conf. (APAC'01), Beijing, China, Sep. 2001, paper THP037, pp. XX-XX.
- J. Peters, “A Phase Measurement System for RF Pulses”, in Proc. 1988 Linear Accelerator Conf. (LINAC'88), Williamsburg, VA, USA, Oct. 1988, paper TH3-04, pp. 535-537.
- R. Demitra, A. Biagioni, L. Crincoli, M. Ferrario, and R. Pompili, “3D characterization of plasma density in capillary discharges for plasma-based accelerators”, presented at the 16th Int. Particle Accelerator Conf. (IPAC'25), Taipei, Taiwan, Jun. 2025, paper TUPS113, this conference.
Back to search