Warning
The page numbers for some of these references could not be added automatically. You must provide the page numbers from the original proceedings which is located at JACoW.org, and substitute ‘pp. XX-XX’ with the correct page numbers.
Favourites
For Word
[n] X. R. Resende et al., “Study of a Pulsed Sextupole Magnet Injection System for LNLS”, in Proc. IPAC'11, San Sebastian, Spain, Sep. 2011, paper THPC139, pp. 3212-3214.
[n] A. Ajguirei, I. Baichev, and J.-B. Jeanneret, “Beam Losses Far Downstream of the High Luminosity Interaction Points of LHC”, in Proc. EPAC'00, Vienna, Austria, Jun. 2000, paper MOP6B13, pp. 355-357.
[n] Y. Iwashita et al., “Quality Improvement of Laser-produced Protons by Phase Rotation and its Possible Extension to High Energies”, in Proc. LINAC'08, Victoria, Canada, Sep.-Oct. 2008, paper MOP060, pp. 214-216.
[n] A. P. Strokach, P. V. Bogdanov, A. V. Galchuck, V. G. Mudrolubov and M. F. Vorogushin, “MCC-30/15 Cyclotron - Parameters, Adjusting Works and their Results”, in Proc. RuPAC'10, Protvino, Russia, Sep.-Oct. 2010, paper FRCHA03, pp. 408-410.
[n] H. N. Jungwirth, L. D. Bruins, A. H. Botha, and J. L. Pabot, “Design of Magnets for an Open-Sector Cyclotron”, in Proc. Cyclotrons'75, Zurich, Switzerland, Aug. 1975, paper C-14, pp. 193-196.
[n] Y. Iwashita et al., “Creation of Peaks in the Energy Spectrum of Laser-Produced Ions by Phase Rotation”, in Proc. LINAC'06, Knoxville, TN, USA, Aug. 2006, paper MOP028, pp. 97-99.
[n] X. Escaler, D. Juan Garcia, J. J. Casas, C. Colldelram, M. Prieto, and M. Quispe, “Numerical Simulation of the ALBA Synchrotron Light Source Cooling System Response to Pump Start-Up and Shut-Down”, in Proc. MEDSI'16, Barcelona, Spain, Sep. 2016, pp. 187-190. doi:10.18429/JACoW-MEDSI2016-TUPE13
[n] L. Maci?â, J. J. Casas, C. Colldelram, and M. Quispe, “Hydraulic Failure Caused by Air in Pipelines of the Experimental Area Ring of ALBA Synchrotron Light Source: Research, Simulations and Solutions”, in Proc. MEDSI'16, Barcelona, Spain, Sep. 2016, pp. 105-107. doi:10.18429/JACoW-MEDSI2016-MOPE43
[n] A. Chapman-Hatchett, V. Chohan, and T. E. d'Amico, “Tune Measurement for the CERN Proton Synchrotron Booster Rings using DSP in VME”, in Proc. PAC'99, New York, NY, USA, Mar. 1999, paper WEA146, pp. 2202-2204.
[n] E. J. Montgomery et al., “Development of Alkali-Based High Quantum Efficiency Semiconductors for Dispenser Photocathodes”, in Proc. PAC'11, New York, NY, USA, Mar.-Apr. 2011, paper THP208, pp. 2510-2512.
[n] S. Funkner et al., “Implementation of Ultra-Low Frequency Non-Linear Raman Spectroscopy with the Gun Laser at FLUTE”, in Proc. IPAC'18, Vancouver, Canada, Apr.-May 2018, pp. 4242-4244. doi:10.18429/JACoW-IPAC2018-THPMF072
[n] C. Garion, P. Costa Pinto, M. A. Gallilee, and J. Perez Espinos, “Development of Vacuum Chamber in Low Z Material”, in Proc. IPAC'13, Shanghai, China, May 2013, paper THPFI057, pp. 3421-3423.
[n] H. Nakanishi et al., “FPGA Digital Timing System for Fusion Plasma Diagnostics in LHD”, in Proc. ICALEPCS'09, Kobe, Japan, Oct. 2009, paper TUP057, pp. 212-214.
[n] R. Ainsworth, S. Chaurize, I. Kourbanis, and E. G. Stern, “Transition Crossing in the Main Injector for PIP-II”, in Proc. IPAC'17, Copenhagen, Denmark, May 2017, pp. 3347-3349. doi:10.18429/JACoW-IPAC2017-WEPVA039
[n] G. P?Âplau, U. Van Rienen, M. J. de Loos, and S. B. van der Geer, “Progress in 3D Space-charge Calculations in the GPT Code”, in Proc. EPAC'04, Lucerne, Switzerland, Jul. 2004, paper THPLT048, pp. 2592-2594.
[n] A. Zaltsman et al., “Progress of High Power FPC development for ERI SRF Cavities”, presented at the IPAC'23, Venice, Italy, May 2023, paper WEPA138, unpublished.
[n] Y. Suzuki et al., “Upgrade of a Low-Level Controller of Magnet Power Supply”, in Proc. ICALEPCS'03, Gyeongju, Korea, Oct. 2003, paper MP571, pp. XX-XX.
[n] G. Maire, A. Kehrli, M. Pezzetti, S. Ravat, B. Charnier, and H. Coppier, “Evaluation and Implementation of Advanced Process Control with the compactRIO Material of National Instrument”, in Proc. ICALEPCS'13, San Francisco, CA, USA, Oct. 2013, paper THPPC125, pp. 1355-1358.
For LaTeX
Use Complete Form
For BibTeX
References
- X. R. Resende et al., “Study of a Pulsed Sextupole Magnet Injection System for LNLS”, in Proc. 2nd Int. Particle Accelerator Conf. (IPAC'11), San Sebastian, Spain, Sep. 2011, paper THPC139, pp. 3212-3214.
- A. Ajguirei, I. Baichev, and J.-B. Jeanneret, “Beam Losses Far Downstream of the High Luminosity Interaction Points of LHC”, in Proc. 7th European Particle Accelerator Conf. (EPAC'00), Vienna, Austria, Jun. 2000, paper MOP6B13, pp. 355-357.
- Y. Iwashita et al., “Quality Improvement of Laser-produced Protons by Phase Rotation and its Possible Extension to High Energies”, in Proc. 24th Linear Accelerator Conf. (LINAC'08), Victoria, Canada, Sep.-Oct. 2008, paper MOP060, pp. 214-216.
- A. P. Strokach, P. V. Bogdanov, A. V. Galchuck, V. G. Mudrolubov and M. F. Vorogushin, “MCC-30/15 Cyclotron - Parameters, Adjusting Works and their Results”, in Proc. 22nd Russian Particle Accelerator Conf. (RuPAC'10), Protvino, Russia, Sep.-Oct. 2010, paper FRCHA03, pp. 408-410.
- H. N. Jungwirth, L. D. Bruins, A. H. Botha, and J. L. Pabot, “Design of Magnets for an Open-Sector Cyclotron”, in Proc. 7th Int. Cyclotron Conf. (Cyclotrons'75), Zurich, Switzerland, Aug. 1975, paper C-14, pp. 193-196.
- Y. Iwashita et al., “Creation of Peaks in the Energy Spectrum of Laser-Produced Ions by Phase Rotation”, in Proc. 23rd Linear Accelerator Conf. (LINAC'06), Knoxville, TN, USA, Aug. 2006, paper MOP028, pp. 97-99.
- X. Escaler, D. Juan Garcia, J. J. Casas, C. Colldelram, M. Prieto, and M. Quispe, “Numerical Simulation of the ALBA Synchrotron Light Source Cooling System Response to Pump Start-Up and Shut-Down”, in Proc. 9th Mechanical Engineering Design of Synchrotron Radiation Equipment and Instrumentation Conf. (MEDSI'16), Barcelona, Spain, Sep. 2016, pp. 187-190.
- L. Maci?â, J. J. Casas, C. Colldelram, and M. Quispe, “Hydraulic Failure Caused by Air in Pipelines of the Experimental Area Ring of ALBA Synchrotron Light Source: Research, Simulations and Solutions”, in Proc. 9th Mechanical Engineering Design of Synchrotron Radiation Equipment and Instrumentation Conf. (MEDSI'16), Barcelona, Spain, Sep. 2016, pp. 105-107.
- A. Chapman-Hatchett, V. Chohan, and T. E. d'Amico, “Tune Measurement for the CERN Proton Synchrotron Booster Rings using DSP in VME”, in Proc. 18th Particle Accelerator Conf. (PAC'99), New York, NY, USA, Mar. 1999, paper WEA146, pp. 2202-2204.
- E. J. Montgomery et al., “Development of Alkali-Based High Quantum Efficiency Semiconductors for Dispenser Photocathodes”, in Proc. 24th Particle Accelerator Conf. (PAC'11), New York, NY, USA, Mar.-Apr. 2011, paper THP208, pp. 2510-2512.
- S. Funkner et al., “Implementation of Ultra-Low Frequency Non-Linear Raman Spectroscopy with the Gun Laser at FLUTE”, in Proc. 9th Int. Particle Accelerator Conf. (IPAC'18), Vancouver, Canada, Apr.-May 2018, pp. 4242-4244.
- C. Garion, P. Costa Pinto, M. A. Gallilee, and J. Perez Espinos, “Development of Vacuum Chamber in Low Z Material”, in Proc. 4th Int. Particle Accelerator Conf. (IPAC'13), Shanghai, China, May 2013, paper THPFI057, pp. 3421-3423.
- H. Nakanishi et al., “FPGA Digital Timing System for Fusion Plasma Diagnostics in LHD”, in Proc. 12th Int. Conf. on Accelerator and Large Experimental Physics Control Systems (ICALEPCS'09), Kobe, Japan, Oct. 2009, paper TUP057, pp. 212-214.
- R. Ainsworth, S. Chaurize, I. Kourbanis, and E. G. Stern, “Transition Crossing in the Main Injector for PIP-II”, in Proc. 8th Int. Particle Accelerator Conf. (IPAC'17), Copenhagen, Denmark, May 2017, pp. 3347-3349.
- G. P?Âplau, U. Van Rienen, M. J. de Loos, and S. B. van der Geer, “Progress in 3D Space-charge Calculations in the GPT Code”, in Proc. 9th European Particle Accelerator Conf. (EPAC'04), Lucerne, Switzerland, Jul. 2004, paper THPLT048, pp. 2592-2594.
- A. Zaltsman et al., “Progress of High Power FPC development for ERI SRF Cavities”, presented at the 14th Int. Particle Accelerator Conf. (IPAC'23), Venice, Italy, May 2023, paper WEPA138, unpublished.
- Y. Suzuki et al., “Upgrade of a Low-Level Controller of Magnet Power Supply”, in Proc. 9th Int. Conf. on Accelerator and Large Experimental Physics Control Systems (ICALEPCS'03), Gyeongju, Korea, Oct. 2003, paper MP571, pp. XX-XX.
- G. Maire, A. Kehrli, M. Pezzetti, S. Ravat, B. Charnier, and H. Coppier, “Evaluation and Implementation of Advanced Process Control with the compactRIO Material of National Instrument”, in Proc. 14th Int. Conf. on Accelerator and Large Experimental Physics Control Systems (ICALEPCS'13), San Francisco, CA, USA, Oct. 2013, paper THPPC125, pp. 1355-1358.
Back to search