Warning
The page numbers for some of these references could not be added automatically. You must provide the page numbers from the original proceedings which is located at JACoW.org, and substitute ‘pp. XX-XX’ with the correct page numbers.
Favourites
For Word
[n] G. Sattonnay et al., “Is it Possible to Use Additive Manufacturing for Accelerator UHV Beam Pipes?”, in Proc. IPAC'19, Melbourne, Australia, May 2019, pp. 2240-2243. doi:10.18429/JACoW-IPAC2019-WEXXPLS3
[n] D. H. Bilderback, “Energy Recovery Linac Experimental Challenges”, in Proc. FLS'06, Hamburg, Germany, May 2006, paper PLT03, pp. XX-XX.
[n] S. Morales Vigo et al., “Calibration of the LHC Diamond beam loss monitors for LHC Run 3”, in Proc. IPAC'23, Venice, Italy, May 2023, pp. 4641-4644. doi:10.18429/JACoW-IPAC2023-THPL085
[n] L. Reginato, C. Peters, D. Vanecek, S. Yu, and F. Deadrick, “Engineering Conceptual Design of the Relativistic Klystron Two-Beam Accelerator Based Power Source for 1-TeV Next Linear Collider”, in Proc. PAC'95, Dallas, TX, USA, May 1995, paper RPC18, pp. 743-745.
For LaTeX
Use Complete Form
For BibTeX
References
- G. Sattonnay et al., “Is it Possible to Use Additive Manufacturing for Accelerator UHV Beam Pipes?”, in Proc. 10th Int. Particle Accelerator Conf. (IPAC'19), Melbourne, Australia, May 2019, pp. 2240-2243.
- D. H. Bilderback, “Energy Recovery Linac Experimental Challenges”, in Proc. 37th ICFA Advanced Beam Dynamics Workshop on Future Light Sources (FLS'06), Hamburg, Germany, May 2006, paper PLT03, pp. XX-XX.
- S. Morales Vigo et al., “Calibration of the LHC Diamond beam loss monitors for LHC Run 3”, in Proc. 14th Int. Particle Accelerator Conf. (IPAC'23), Venice, Italy, May 2023, paper THPL085, pp. 4641-4644.
- L. Reginato, C. Peters, D. Vanecek, S. Yu, and F. Deadrick, “Engineering Conceptual Design of the Relativistic Klystron Two-Beam Accelerator Based Power Source for 1-TeV Next Linear Collider”, in Proc. 16th Particle Accelerator Conf. (PAC'95), Dallas, TX, USA, May 1995, paper RPC18, pp. 743-745.
Back to search