Warning
The page numbers for some of these references could not be added automatically. You must provide the page numbers from the original proceedings which is located at JACoW.org, and substitute ‘pp. XX-XX’ with the correct page numbers.
Favourites
For Word
[n] S. Verd??-Andr?®s et al., “A Beam Screen to Prepare the RHIC Vacuum Chamber for EIC Hadron Beams: Conceptual Design and Requirements”, in Proc. IPAC'21, Campinas, Brazil, May 2021, pp. 2066-2069. doi:10.18429/JACoW-IPAC2021-TUPAB260
[n] S. Minaev et al., “Electro-Dynamics Characteristics of RF Wobbler Cell for Heavy Ion Beam”, in Proc. LINAC'10, Tsukuba, Japan, Sep. 2010, paper TUP073, pp. 581-583.
[n] C. W. Owen, C. A. Radmer, and D. E. Young, “High Field Measurements at 200 MHz in Conventional Proton Linear Accelerator Geometries at 5, 50, and 130 MeV”, in Proc. LINAC'66, Los Alamos, NM, USA, Oct. 1966, paper IV-07, pp. 176-182.
[n] D. M. Dykes, “An RF System for the Proposed DIAMOND 3 GeV Light Source”, in Proc. EPAC'94, London, UK, Jun.-Jul. 1994, pp. 1880-1882.
[n] M. A. Pop, F. Curbis, B. S. Kyle, S. P. Pirani, W. Qin, and S. Werin, “Analysis of the Effect of Energy Chirp in Implementing EEHG at SXL”, in Proc. IPAC'21, Campinas, Brazil, May 2021, pp. 1566-1569. doi:10.18429/JACoW-IPAC2021-TUPAB082
[n] D. M. Dykes, A. J. Moss, and R. J. Smith, “The Provision of High Power CW RF Power for Particle Accelerators”, in Proc. EPAC'02, Paris, France, Jun. 2002, paper TUPLE117, pp. 2305-2307.
[n] A. Hershcovitch et al., “Novel Technique Ion Assisted In-Situ Coating of Long, Small Diameter, Accelerator Beam Pipes with Compacted Thick Crystalline Copper Film”, in Proc. IPAC'19, Melbourne, Australia, May 2019, pp. 4301-4303. doi:10.18429/JACoW-IPAC2019-THPTS080
[n] M. Abs, J. M. Capdevila, T. Delvigne, F. Genin, Y. Jongen, and A. Nguyen, “RHODOTRON Accelerators for Industrial Electron-Beam Processing: A Progress Report”, in Proc. EPAC'96, Sitges, Spain, Jun. 1996, paper THP076G, pp. 2687-2692.
[n] J. C. Yang, “Challenges & Status of HIAF Project and Brief Introduction of Ciads Project in China”, presented at the HB'23, Geneva, Switzerland, Oct. 2023, paper MOA2I2, unpublished.
[n] N. Elias et al., “The testing experience of the cryomodules for the ESS beam on target phase at 2 MW capability”, in Proc. IPAC'24, Nashville, TN, USA, May 2024, pp. 1949-1952. doi:10.18429/JACoW-IPAC2024-WECN3
[n] B. Bayanov, V. Belov, S. Taskaev, and E. Zhoorov, “Neutron producing target for accelerator based neutron capture therapy”, in Proc. RuPAC'06, Novosibirsk, Russia, Sep. 2006, paper MOLP11, pp. XX-XX.
[n] E. S. Kim, “Simulation of The Muon Cooling Channel in Linear RF Systems”, in Proc. LINAC'02, Gyeongju, Korea, Aug. 2002, paper TU486, pp. 518-520.
[n] P. Fessia et al., “The LHC Continuous Cryostat Interconnections: the Organization of a Logistically Complex Worksite Requiring Strict Quality Standards and High Output”, in Proc. EPAC'08, Genoa, Italy, Jun. 2008, paper WEPD012, pp. 2428-2430.
[n] C. W. Owen, “Status of Accelerator Development at Fermilab”, in Proc. LINAC'76, Chalk River, Canada, Sep. 1976, paper E01, pp. 251-253.
[n] C. D. Curtis et al., “Operation of NAL Linac at Energies to 139 MeV”, in Proc. LINAC'70, Batavia, IL, USA, Sep.-Oct. 1970, paper C-3, pp. 217-238.
[n] A. Ratti et al., “Results of The SNS Front End Commissioning at Berkeley Lab”, in Proc. LINAC'02, Gyeongju, Korea, Aug. 2002, paper TU483, pp. 509-511.
[n] M. Switka and K. Desch, “Feasibility investigation of a low energy laser driven plasma injector for ELSA”, in Proc. IPAC'23, Venice, Italy, May 2023, pp. 1526-1528. doi:10.18429/JACoW-IPAC2023-TUPA088
[n] M. Titberidze et al., “Novel Femtosecond Level Synchronization of Titanium Sapphire Laser and Relativistic Electron Beams”, in Proc. IBIC'14, Monterey, CA, USA, Sep. 2014, paper MOPD12, pp. 174-178.
[n] D. Wolff, C. Briegel, J. Dinkel, and H. Pfeffer, “Improving Regulation in the Fermilab Main Ring Magnet Power Supply System”, in Proc. PAC'81, Washington D.C., USA, Mar. 1981, pp. 3088-3091.
[n] A. Hershcovitch et al., “Apparatus and Technique for Measuring Low RF Resistivity of Tube Coatings at Cryogenic Temperatures”, in Proc. IPAC'14, Dresden, Germany, Jun. 2014, pp. 4046-4048. doi:10.18429/JACoW-IPAC2014-THPRI114
[n] V. A. Koshelev et al., “Design of 4-vane RFQ with Magnetic Coupling Windows for Nuclotron Injector Lu-20”, in Proc. LINAC'16, East Lansing, MI, USA, Sep. 2016, pp. 575-577. doi:10.18429/JACoW-LINAC2016-TUPLR050
[n] D. J. Dunning et al., “Start-to-End Simulations of the CLARA FEL Test Facility”, in Proc. IPAC'18, Vancouver, Canada, Apr.-May 2018, pp. 4430-4433. doi:10.18429/JACoW-IPAC2018-THPMK060
For LaTeX
Use Complete Form
For BibTeX
References
- S. Verd??-Andr?®s et al., “A Beam Screen to Prepare the RHIC Vacuum Chamber for EIC Hadron Beams: Conceptual Design and Requirements”, in Proc. 12th Int. Particle Accelerator Conf. (IPAC'21), Campinas, Brazil, May 2021, pp. 2066-2069.
- S. Minaev et al., “Electro-Dynamics Characteristics of RF Wobbler Cell for Heavy Ion Beam”, in Proc. 25th Linear Accelerator Conf. (LINAC'10), Tsukuba, Japan, Sep. 2010, paper TUP073, pp. 581-583.
- C. W. Owen, C. A. Radmer, and D. E. Young, “High Field Measurements at 200 MHz in Conventional Proton Linear Accelerator Geometries at 5, 50, and 130 MeV”, in Proc. 1966 Linear Accelerator Conf. (LINAC'66), Los Alamos, NM, USA, Oct. 1966, paper IV-07, pp. 176-182.
- D. M. Dykes, “An RF System for the Proposed DIAMOND 3 GeV Light Source”, in Proc. 4th European Particle Accelerator Conf. (EPAC'94), London, UK, Jun.-Jul. 1994, pp. 1880-1882.
- M. A. Pop, F. Curbis, B. S. Kyle, S. P. Pirani, W. Qin, and S. Werin, “Analysis of the Effect of Energy Chirp in Implementing EEHG at SXL”, in Proc. 12th Int. Particle Accelerator Conf. (IPAC'21), Campinas, Brazil, May 2021, pp. 1566-1569.
- D. M. Dykes, A. J. Moss, and R. J. Smith, “The Provision of High Power CW RF Power for Particle Accelerators”, in Proc. 8th European Particle Accelerator Conf. (EPAC'02), Paris, France, Jun. 2002, paper TUPLE117, pp. 2305-2307.
- A. Hershcovitch et al., “Novel Technique Ion Assisted In-Situ Coating of Long, Small Diameter, Accelerator Beam Pipes with Compacted Thick Crystalline Copper Film”, in Proc. 10th Int. Particle Accelerator Conf. (IPAC'19), Melbourne, Australia, May 2019, pp. 4301-4303.
- M. Abs, J. M. Capdevila, T. Delvigne, F. Genin, Y. Jongen, and A. Nguyen, “RHODOTRON Accelerators for Industrial Electron-Beam Processing: A Progress Report”, in Proc. 5th European Particle Accelerator Conf. (EPAC'96), Sitges, Spain, Jun. 1996, paper THP076G, pp. 2687-2692.
- J. C. Yang, “Challenges & Status of HIAF Project and Brief Introduction of Ciads Project in China”, presented at the HB'23 (HB), Geneva, Switzerland, Oct. 2023, paper MOA2I2, unpublished.
- N. Elias et al., “The testing experience of the cryomodules for the ESS beam on target phase at 2 MW capability”, in Proc. 15th Int. Particle Accelerator Conf. (IPAC'24), Nashville, TN, USA, May 2024, paper WECN3, pp. 1949-1952.
- B. Bayanov, V. Belov, S. Taskaev, and E. Zhoorov, “Neutron producing target for accelerator based neutron capture therapy”, in Proc. 20th Russian Particle Accelerator Conf. on Charged Particle Accelerators (RuPAC'06), Novosibirsk, Russia, Sep. 2006, paper MOLP11, pp. XX-XX.
- E. S. Kim, “Simulation of The Muon Cooling Channel in Linear RF Systems”, in Proc. 21st Linear Accelerator Conf. (LINAC'02), Gyeongju, Korea, Aug. 2002, paper TU486, pp. 518-520.
- P. Fessia et al., “The LHC Continuous Cryostat Interconnections: the Organization of a Logistically Complex Worksite Requiring Strict Quality Standards and High Output”, in Proc. 11th European Particle Accelerator Conf. (EPAC'08), Genoa, Italy, Jun. 2008, paper WEPD012, pp. 2428-2430.
- C. W. Owen, “Status of Accelerator Development at Fermilab”, in Proc. 1976 Proton Linear Accelerator Conf. (LINAC'76), Chalk River, Canada, Sep. 1976, paper E01, pp. 251-253.
- C. D. Curtis et al., “Operation of NAL Linac at Energies to 139 MeV”, in Proc. 1970 Linear Accelerator Conf. (LINAC'70), Batavia, IL, USA, Sep.-Oct. 1970, paper C-3, pp. 217-238.
- A. Ratti et al., “Results of The SNS Front End Commissioning at Berkeley Lab”, in Proc. 21st Linear Accelerator Conf. (LINAC'02), Gyeongju, Korea, Aug. 2002, paper TU483, pp. 509-511.
- M. Switka and K. Desch, “Feasibility investigation of a low energy laser driven plasma injector for ELSA”, in Proc. 14th Int. Particle Accelerator Conf. (IPAC'23), Venice, Italy, May 2023, paper TUPA088, pp. 1526-1528.
- M. Titberidze et al., “Novel Femtosecond Level Synchronization of Titanium Sapphire Laser and Relativistic Electron Beams”, in Proc. 3rd Int. Beam Instrumentation Conf. (IBIC'14), Monterey, CA, USA, Sep. 2014, paper MOPD12, pp. 174-178.
- D. Wolff, C. Briegel, J. Dinkel, and H. Pfeffer, “Improving Regulation in the Fermilab Main Ring Magnet Power Supply System”, in Proc. 9th Particle Accelerator Conf. (PAC'81), Washington D.C., USA, Mar. 1981, pp. 3088-3091.
- A. Hershcovitch et al., “Apparatus and Technique for Measuring Low RF Resistivity of Tube Coatings at Cryogenic Temperatures”, in Proc. 5th Int. Particle Accelerator Conf. (IPAC'14), Dresden, Germany, Jun. 2014, pp. 4046-4048.
- V. A. Koshelev et al., “Design of 4-vane RFQ with Magnetic Coupling Windows for Nuclotron Injector Lu-20”, in Proc. 28th Linear Accelerator Conf. (LINAC'16), East Lansing, MI, USA, Sep. 2016, pp. 575-577.
- D. J. Dunning et al., “Start-to-End Simulations of the CLARA FEL Test Facility”, in Proc. 9th Int. Particle Accelerator Conf. (IPAC'18), Vancouver, Canada, Apr.-May 2018, pp. 4430-4433.
Back to search